How to Use Skanunu:
There are two ways to clean your bearing sets with Skanunu Really Wet and Slippery Bearing Cleaner & Lube and a little goes a long way: On-The-Fly & Deep Clean

1) ON-THE-FLY:
1) Apply a small amount of Skanunu Really Wet and Slippery Bearing Cleaner & Lube directly to the inner and outer bearing sets of all four wheels. 2) Spin wheel for maximum penetration
then wipe up excess with paper
towel or cloth*. Reapply as necessary.



2) DEEP CLEAN: (Have a look at this video)

Remove all your bearing sets from the wheels.
Place them in Skanunu Really Wet and Slippery Bearing Cleaner & Lube and let them soak for a minute allowing it to get into each set. (You could take off the shields and remove the retainer then clean inside the inner race and around the bearings if you know how to do this.*)
Wipe off each set with a paper towel or rag then place them back into wheels. Your are ready to ride. (If you disassembled the set, wipe out all the components with a cotton swab taking care NOT to lose any bearings. Then reassemble the set*)
Skanunu Really Wet and Slippery Bearing Cleaner & Lube will intentionally feel wet even after you wipe it off. This is because the protectant and lube are left behind on your bearings.